General Information - Dodge journey 2017 Owner's Manual

Hide thumbs Also See for journey 2017:
Table of Contents

Advertisement

• Once you repair or replace the original road tire and
reinstall it on the vehicle in place of the compact spare,
the TPMS will update automatically. In addition, the
"Tire Pressure Monitoring Telltale Light" will turn off
and the graphic in the instrument cluster will display a
new pressure value instead of dashes (- -), as long as no
tire pressure is below the low-pressure warning limit in
any of the four active road tires. The vehicle may need to
be driven for up to 10 minutes above 15 mph (24 km/h)
in order for the TPMS to receive this information.
TPMS Deactivation — If Equipped
The TPMS can be deactivated if replacing all four wheel
and tire assemblies (road tires) with wheel and tire assem-
blies that do not have TPMS Sensors, such as when
installing Winter wheel and tire assemblies on your ve-
hicle. To deactivate the TPMS, first, replace all four wheel
and tire assemblies (road tires) with tires not equipped
with Tire Pressure Monitoring (TPM) Sensors. Then, drive
the vehicle for 20 minutes above 15 mph (24 km/h). The
TPMS will chime, the "TPM Telltale Light" will flash on
and off for 75 seconds and then remain on and the
instrument cluster will display the "SERVICE TPM SYS-
TEM" message and then display dashes (--) in place of the
pressure values. Beginning with the next ignition switch
cycle, the TPMS will no longer chime or flash the TPM
telltale and display the "SERVICE TPM SYSTEM" message
in the instrument cluster display but dashes (--) will remain
in place of the pressure values.
To reactivate the TPMS, replace all four wheel and tire
assemblies (road tires) with tires equipped with TPM
sensors. Then, drive the vehicle for up to 20 minutes above
15 mph (24 km/h). The TPMS will chime, the "TPM Telltale
Light" will flash on and off for 75 seconds and then turn
off, and the instrument cluster will display the "SERVICE
TPM SYSTEM" message. The instrument cluster will also
display pressure values in place of the dashes. On the next
ignition switch cycle the "SERVICE TPM SYSTEM" mes-
sage will no longer be displayed as long as no system fault
exists.

General Information

The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
STARTING AND OPERATING 393
5

Advertisement

Table of Contents
loading

Table of Contents