How To Install The Hob - CDA HC3616FR Installation, Use And Maintenance Manual

How to Install the Hob

Overall dimensions of the hob:
Width: 300 mm Depth: 520 mm
Worktop cut-out dimensions:
Width: 285 mm Depth: 490 mm
1. Make the required hole in the worktop.
Before doing this, you must check the
instructions supplied with any cooker hood to ensure that you will
have the required clearance. The cut-out (Fig.8) shows a 60mm gap
from the worktop edge to the cut-out edge. The distance from the
hob, when fitted, to the back wall should be 50mm.
If a splashback/worktop upstand is to be fitted, take this into account
when cutting the hole. The minimum distance that the hob should be
positioned away from the rear wall or splashback is 50mm.
2. Make sure that
the worktop is
clean and dust
free and insert
the hob into the
cut-out opening.
Press the hob
firmly into place
so that the seal
connects with
the worktop (Fig.
7).
18
Rear Wall
Cut-out
Front edge of worktop
Fig.8
1
1 - Worktop
2 - Hob seal
3 - Ceramic hob
Fig.7
285
Adjacent vertical surface
Min.
(cupboard etc. -
55
Measurement applicable
to both sides.)
2 3