CDA HC3616FR Installation, Use And Maintenance Manual page 6

Using Your Hob
To switch the hob on
• To switch the power on, touch and hold the "On/off sensor" (1)
approximately one second. The hob will beep and all displays will
show "0".
Please note: When switching the hob on after the appliance has been
switched off at the mains, both cooking zone displays may show an
" ". This is normal and they should disappear after approximately
one hour. If the hob is used during this time however, then an " " will
appear to indicate that the relevant zone is still hot to the touch and
will subsequently disappear after a certain amount of time.
To activate a zone and set a power level
• Simply switch the hob on, select the desired zone using the relevant
cooking zone selector and use the plus or minus setting selectors
to set the required power level. The power levels range from 1
(minimum) to 9 (maximum). The hob will then begin heating.
Please note: If a power level is not set within ten seconds of switching
the hob on, the hob will switch off automatically.
To deactivate a zone
• Simply activate zone control by touching the relevant zone's
selector and then touch the plus and minus setting selectors
simultaneously. Alternatively, you can use the minus setting selector
(2) to return the power level to 0. The cooking zone indicator will
display a "0" to confirm that the zone is now inactive.
• If switching off both zones, the above step needs to be taken
6
for