Advertisement
Notes:
•
Do not position this appliance above a refrigeration unit. The heat
generated may cause the unit to fail.
•
This appliance is designed to be installed into cabinet units capable of
withstanding temperatures of 65°C above ambient or greater (typically
80-90°C).
•
If the hob is to be installed above a working drawer, then a partition
should be fitted to protect the contents and user from the heat
generated during use. This should be fitted 100mm below the hob.
•
Never place perishable foods in the cupboard below the appliance.
How To Install The Hob
How to install the hob:
Overall dimensions of the hob:
Worktop cut-out dimensions:
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig 4) shows a
61.5mm gap from the wall to the cut-out edge. The distance for the
hob, when fitted, to the back wall is 50mm.
2. Unless the seal is already fitted position the hob seal, as shown
in the diagram below (Fig 6), ensuring that the ends meet without
overlapping. Do not use silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig 7).
Remove any excess sealant after tightening the brackets.
4. Place the terminal cover plate into place over the terminal and feed
12
Width: 290mm
Width: 270mm
Depth: 510mm
Depth: 490mm
Advertisement
