Other Applications; Auto Focus Assist Beam; Bounce Flash; Creating A Catchlight - Godox thinklite TTL TT350 Instruction Manual

Other Applications

Auto Focus Assist Beam

In poorly-lit or low-contrast shooting environments, the built-in auto
focus assist beam will automatically light on to make it easier for
autofocus. The beam will light up only when autofocus is difficult
and get out as soon as the autofocus becomes correct.
If you want to turn off the auto focus assist beam, set the "AF" to
"OFF" on the C.Fn settings.
Position
Effective Range
Center
0.6~4m
Periphery
0.6~2.5m

Bounce Flash

By pointing the flash head toward a wall or ceiling, the flash will
bounce off the surface before illuminating the subject. This can
soften shadows behind the subject for a more natural-looking shot.
This is called bounce flash.
To set the bounce direction, hold the flash head and turn it to a
satisfying angle.
270
- 41 -
-7-90
If the wall or ceiling is too far away, the bounced flash might
●
be too weak and result in underexposure.
The wall or ceiling should be a plain, white color for high
●
reflectance. If the bounce surface is not white, a color cast
may appear in the picture.

Creating a Catchlight

With the catchlight panel, you can create a catchlight in the subject's
eyes to add life to the facial expression.
1
2
3
Point the flash head straight ahead and then upward by 90°.
●
The catchlight will not appear if you swing the flash head left
or right.
For best catchlight effect, stay 1.5m/4.9ft away from the
●
subject.
ZOOM: Setting the Flash Coverage and Using
the Wide Panel
The flash coverage can be set automatically or manually. It can be
set to match the lens focal length from 24mm to 105mm. Also, with
the built-in wide panel, the flash coverage can be expanded for
14mm wide-angle lenses.
In Manual Zoom mode, press the
<ZOOM> button.
ZOOM SYNC SLAVE
●
SET
●
● If you set the flash coverage manually, make sure it covers
the lens focal length so that the picture will not have a dark
periphery.
When the low battery indicator is displayed, the ZOOM can
●
not be adjusted, it will constantly be 24mm.
Point the flash head upward by
90°.
Pull out the wide panel. The
catchlight panel will come out
at the same time.
Push the wide panel back in.
● Push in only the wide panel.
Follow the same procedures
●
as for bounce flash.
Turn the Select Dial to change
the flash coverage.
If < AU > is displayed, the flash
coverage will be set
automatically.
- 42 -