Other Applications - Godox TT685II-N User Manual

Please downgrade the flash power output. If the flash is in TTL mode, please try
•
to change it to M mode (a preflash is needed in TTL mode).
3. Whether the distance between the flash trigger and the flash is too close or
not (<0.5m)
Please turn on the "close distance wireless mode" on the flash trigger
•
X2 & X1 series: press the test button and hold on, then turning it on until the flash
•
ready indicator blinks for 2 times.
XPro series: Set the C.Fn-DIST to 0-30m.
•
4. Whether the flash trigger and the receiver end equipment are in the low
battery states or not.
Please replace the battery (the flash trigger is recommended to use 1.5V
•
disposable alkaline battery).

Other Applications

Sync Triggering
The Sync Cord Jack is a Φ2.5mm plug. Insert a trigger plug here and the flash will be fired
synchronously with the camera shutter.
Auto Focus Assist Beam
In poorly lit or low contrast shooting environments, the built-in auto focus assist beam
will automatically light on to make it easier for the autofocus. The beam will light up only
when autofocus is difficult and get out as soon as the autofocus becomes correct.
If you want to turn off the auto focus assist beam, set the "AF" to "OFF" on
the C.Fn settings.
If you find he auto assist beam does not light up, this is because the camera has
•
got a correct autofocus.
Position
Center
Periphery
Bounce Flash
By pointing the flash head toward a wall or ceiling, the flash will bounce off the surface
before illuminating the subject. This can soften shadows behind the subject for a more
natural-looking shot.
This is called bounce flash.
To set the bounce direction, hold the flash head and turn it to a satisfying angle.
Effective Range
0.6~10m / 2.0~32.8 feet
0.6~5m / 2.0~16.4 feet
26