Viewing Alarms - Carrier equipment touch User Manual

Viewing alarms
When the controller generates an alarm, the following actions occur in the Equipment Touch:
• turns red. The button remains red as long as Active Alarms or Active Faults exist.
• An audible alarm sounds if the alarm was set up in ViewBuilder to generate a sound and if Alarm Sounds are
turned on in the Touchscreen Setup screen. Touch to silence the alarm.
The alarm is added to the Active Alarms or Active Faults screen. See table below.
To view alarms, touch or touch Alarms on the System screen. The Active Alarms are displayed.
TO***
Active Alarms See all alarms except those that are defined as Faults in the control program.
Active Faults See alarms that are defined as Faults in the control program.
Return-To-Normal See alarms that returned to a normal state.
Manually cleared See alarms that you cleared using the Clear Active button.
Clear Active Clear all active alarms and faults.
NOTE The Equipment Touch can hold up to 100 alarms.
Carrier Proprietary and Confidential
12
Equipment Touch CARRIER CORPORATION @2015
User Guide All rights reserved