Table of Contents
Advertisement
Exit Installation Mode
1. Short press the function button (<2 seconds) to exit install
mode.
2. Verify the unit registers, attaches, and establishes a PDP
context by checking the status on the web UI or when all three
of the LEDs are solid green (see Table 6 - LED state and
sequence).
3. Optionally, verify the unit will correctly recover from a power
cycle by removing and reapplying power. Verify it registers,
attaches, and establishes a PDP context by again checking the
status on the web UI or when all three of the LEDs are solid
green (see Table 6 - LED state and sequence).
4. Verify end to end connectivity of the system, by sending a
small amount of data from the device connected to the 9502
and verifying that the data was received by the other end (e.g.,
data center).
31
Advertisement
Table of Contents
