Table of Contents
Advertisement
30
To adjust azimuth, refer to Figure 17 - Adjusting azimuth
4. Loosen the two bolts on the pole collar.
5. Move the ODU to either side, in small increments, as
necessary to get the optimum signal strength as shown on the
voltmeter or by the fast high pitch sounds that you hear with
the headphones.
When you have maximized the signal quality:
6. Tighten the two bolts in the curved slots on the azimuth
elevation bracket to lock down the elevation adjustment.
7. Be careful not to change the ODU's orientation while
tightening the bolts.
8. Tighten the two bolts on the pole collar to lock down the
azimuth adjustment.
9. Make sure all other fasteners on both brackets are tight.
Advertisement
Table of Contents
