Status Bar; Connections Tab; Manage Contexts Page; Manage Apns Page - Hughes 9502 User Manual

Status Bar
Display Comments
Initializing Initial start up
Pointing UT in pointing mode
Registering Attempting to register -­ pointing mode exited or
bypassed
Registered Registered and attached, no context
Connected PDP context active
Connections Tab
Manage Contexts Page
Manage APNs Page
Settings Tab
The status bar is included on the home page and other pages that
do not have a navigation bar. It includes a field with the elevation
angle and compass direction towards the visible satellite(s).
The status text in the connection section is as shown in Table 3 –
Status Bar below.
The signal strength bar shows the quality of the received signal.
The same scale is used for all beam times and so during pointing
only the left part of the bar is used. The signal strength should be
46 to 52dB when it is pointed.
The Manage Contexts page under the Connections tab displays the
status of any active contexts and allows contexts to be controlled.
Typically this page will not be used and you configure context
activate via the always on option on the M2M page.
The Manage APNs page under the Connections tab allows the user
to view the available APNs and define new ones, e.g. if the correct
APN is not configured in the SIM.
To make an APN the default, select it in the Defined APNs list and
press "Make Default". The selected APN will be moved to the top
of the list and shown in bold font. If an Always on Context is
already defined, you must manually update the configuration on
the M2M page to change to the new APN.
The settings tab has the following configuration pages:
Corresponding LED display
Various
All three LEDs flash 1Hz
PWR on, GPS on or flashing, NET off
PWR on, GPS on or flashing, NET
flashing
All three on (or off after timeout)
11