Ccd/Laser Scan Engine; Reader Settings Table - CipherLab 8000 User Manual

CCD/LASER SCAN ENGINE

The tables below list reader settings as well as symbology settings for the CCD or Laser
scan engine.

READER SETTINGS TABLE

CCD/Laser Engine
Scan Mode
Continuous Mode
Test Mode
Repeat Mode
Momentary Mode
Alternate Mode
Aiming Mode
Laser Mode
Auto Off Mode
Auto Power Off Mode
Description
Non-stop scanning
To decode the same barcode repeatedly, move away the scan beam
and target it at the barcode for each scanning.
Non-stop scanning
Capable of decoding the same barcode repeatedly
Non-stop scanning
Capable of re-transmitting barcode data if triggering within one second
after a successful decoding
Hold down the scan trigger to start with scanning.
The scanning won't stop until you release the trigger.
Press the scan trigger to start with scanning.
The scanning won't stop until you press the trigger again.
Press the scan trigger to aim at a barcode. Within one second, press the
trigger again to decode the barcode.
The scanning won't stop until (a) a barcode is decoded, (b) the pre-set
timeout expires, or (c) you release the trigger.
Hold down the scan trigger to start with scanning.
The scanning won't stop until (a) a barcode is read, (b) the preset
timeout expires, or (c) you release the trigger.
Press the scan trigger to start with scanning.
The scanning won't stop until (a) a barcode is read or (b) the preset
timeout expires.
Press the scan trigger to start with scanning.
The scanning won't stop until the preset timeout expires, and, the
preset timeout period re-counts after each successful decoding.
Appendix II
Default
Laser mode
131