Electrical Requirements And Grounding Instructions - daltile 828 BrS Operating Manual

ELECTRICAL REQUIREMENTS
AND GROUNDING
INSTRUCTIONS.
In order to prevent potential electrical shock
and injury, the following electrical safety pre-
cautions and symbols should be followed at all
times!
In case of a malfunction or breakdown,
grounding provides a path of least
resistance for electric current to redu-
ce the risk of electric shock. This tool is equip-
ped with an electric cord having an equipment-
grounding conductor and a grounding plug.
The plug must be plugged into a matching out-
let that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided – if it will
not fit the outlet; have the proper outlet
installed by a qualified electrician.
Improper connections of the equipment
grounding conductor can result in a risk
of electric shock. The equipment-groun-
ding conductor is the insulated conductor
that has an outer surface that is green with
or without yellow stripes. If repair or repla-
cement of the electric cord or plug is
necessary, do not connect the equipment-
grounding conductor to a live terminal.
Check with a qualified electrician or serv-
ice personnel if the grounding instructions
are not completely understood, or if in
doubt s to whether the tool is properly
grounded.
Use only 3-wire extension cords that have
3-prong grounding plugs and 3-pole
receptacles that accept the tool's plug.
Repair or replace a damaged or worn
cord immediately.
DALTOOL SAFETY
This tool is intended for use on a cir-
cuit that has a 3 pole outlet.
To reduce the risk of electrocutation,
keep all connections dry and off the
ground.
A Ground Fault Circuit Interrupter (GFCI)
should be provided on the circuit(s) or
outlet(s)to be used for the Saw. Receptacles are
available having built-in GFCI protections and
may be used for this measure of safety. A GFCI
is not supplied with the machine.
When using an extension cord, the GFCI should
be installed closest to the power source, follo-
wed by the extension cord and lastly, the saw.
Shock Hazard. For replacement, use only an
identical Daltool water pump, Item # 6.513.298
To avoid the possibility of the machi-
nes plug or electrical outlet getting
wet, position the saw to one side of a
wall mounted outlet. This will prevent
water from dripping onto the outlet or plug. A
"drip loop" should be arranged by the user to
properly position the power cord relative to the
power source. The "drip loop" is that part of the
cord below the level of the outlet, or the con-
nector, if an extension cord is used.
Continued on page 10
DALTILE 828 BrS OPERATING MANUAL V02/2004R1 PAGE 9