Unpacking And Setting Up; Unpacking And Assembly; Cooling System; Connecting To Power Supply - daltile 828 BrS Operating Manual

UNPACKING AND SETTING UP

Unpacking and Assembly

Unpack the tile saw and inspect
for any damaged parts.
Install the legs in the sockets at the under
side of the water container and fasten with
the knobs. Markings show the right
position.
Level the tile saw by adjusting the
legs in the sockets and make sure its
stable.
Release the transportation lock.

Setting the Cutting Depth:

By loosening the knob the saw head can
be positioned at the desired height.
The saw head is tightened by a spring and
may accidentally jump up when the knob
is loosened.
PAGE 12 DALTILE828 BrS OPERATING MANUAL V02/2004R1
Transportation Lock

Cooling System

Operating the water pump without a sufficient
supply of water may result in pump damage.
Place the plug in the drain of the water
container.
Fill the container with water until the
water pump is completely submerged.

Connecting to Power Supply

Before connecting the machine make sure that:
the line voltage corresponds with the data
on the machine's specifications plate,
there is a grounded power supply,
the extension cord's meets criterea as
mentioned in the table on page 10.

Motor Protection

The motor is equiped with a thermal safety
switch for protection against an overload. When
the motor gets overheated, the switch falls back
into its initial position and can only be switched
on again after the motor has cooled down.