Trigger Commands - Honeywell ORBIT 7120PLUS User Manual

Response:
This response indicates that the device's Codabar Coding Enable (CBRENA) is set
to 1, or on.
Example: What are the device's settings for all Codabar selections?
Enter:
Response:
This response indicates that the device's Codabar Coding Enable (CBRENA) is set
to 1, or on;
the Start/Stop Character (SSX) is set to 0, or Don't Transmit;
the Check Character (CK2) is set to 0, or Not Required;
concatenation (CCT) is set to 1, or Enabled;
the Minimum Message Length (MIN) is set to 2 characters;
the Maximum Message Length (MAX) is set to 60 characters;
and the Default setting (DFT) has no value.

Trigger Commands

You can activate and deactivate the scanner with serial trigger commands. First,
you must send a serial menu command for triggering
is in serial trigger mode, the trigger is activated and deactivated by sending the fol-
lowing commands:
Activate:
Deactivate:
The scanner scans until a bar code has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see
for a description, and the serial command on
178
CBRENA1[ACK]
cbr?.
CBRENA1[ACK],
SSX0[ACK],
CK20[ACK],
CCT1[ACK],
MIN2[ACK],
MAX60[ACK],
DFT[ACK].
SYN T CR
SYN U CR
(page 37). Once the scanner
Read Time-Out
page 185).
Orbit 7120plus/7190g User Guide
on page 37