User-Specified Reread Delay; 2D Reread Delay; Illumination Lights - Honeywell ORBIT 7120PLUS User Manual

User-Specified Reread Delay

If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart,

2D Reread Delay

Sometimes 2D bar codes can take longer to read than other bar codes. If you wish
to set a separate Reread Delay for 2D bar codes, scan one of the programming
codes that follows. 2D Reread Delay Off indicates that the time set for
Delay

Illumination Lights

Note: This feature is not supported by the Orbit 7120plus scanner.
If you want the illumination lights on while reading a bar code, scan the Lights On
bar code, below. However, if you want to turn just the lights off, scan the Lights Off
bar code. Default = Lights On.
Orbit 7120plus/7190g User Guide
beginning on page 225, then scanning Save.
is used for both 1D and 2D bar codes. Default = 2D Reread Delay Off.
Short (500 ms)
Long (1000ms)
2D Reread Delay Off
User-Specified Reread Delay
Reread
* Medium (750ms)
Extra Long (2000ms)
43