Honeywell ORBIT 7120PLUS User Manual page 121

UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the begin-
ning of the scanned data, but the unit can be programmed so it will not transmit it
(Off). Default = On.
UPC-A Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-A data.
Default = Off for both 2 Digit and 5 Digit Addenda.
UPC-A Addenda Required
When Required is scanned, the scanner will only read UPC-A bar codes that have
addenda. You must then turn on a 2 or 5 digit addenda listed on
Default = Not Required.
Orbit 7120plus/7190g User Guide
* On
2 Digit Addenda On
5 Digit Addenda On
Required
Off
* 2 Digit Addenda Off
* 5 Digit Addenda Off
page 107.
107