Table of Contents
Advertisement
the Minimum Message Length (MIN) is set to 2 characters;
the Maximum Message Length (MAX) is set to 60 characters;
and the Default setting (DFT) has no value.
Trigger Commands
You can activate and deactivate the scanner with serial trigger commands. First, the scanner must be put in Manual Trigger
Mode by scanning a Manual Trigger Mode bar code
Once the scanner is in serial trigger mode, the trigger is activated and deactivated by sending the following commands:
Activate:
SYN T CR
Deactivate: SYN U CR
The scanner scans until a bar code has been read, until the deactivate command is sent, or until the serial time-out has been
reached (see "Read Time-Out" on page 3-6 for a description, and the serial command on
Resetting the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate Custom Defaults bar code below. This
resets the scanner to the custom default settings. If there are no custom defaults, it will reset the scanner to the factory default
settings. Any settings that have not been specified through the custom defaults will be defaulted to the factory default settings.
The charts on the following pages list the factory default settings for each of the commands (indicated by an asterisk (*) on the
programming pages).
Menu Commands
Selection
Product Default Settings
Setting Custom Defaults
Resetting the Custom Defaults
Programming the Interface
Plug and Play Codes
Plug and Play Codes:
RS485
Plug and Play Codes: IBM SurePos
(page
3-5), or by sending a serial menu command for triggering
Activate Custom Defaults
Setting
* Indicates default
Set Custom Defaults
Save Custom Defaults
Activate Custom Defaults
Keyboard Wedge:
IBM PC AT and Compatibles with CR suffix
Laptop Direct Connect with CR suffix
RS232 Serial Port
IBM Port 5B Interface
IBM Port 9B HHBCR-1 Interface
IBM Port 17 Interface
IBM Port 9B HHBCR-2 Interface
RS485 Packet Mode On
RS485 Packet Mode Off
RS485 Packet Length (20-256)
USB IBM SurePos Handheld
USB IBM SurePos Tabletop
(page
page
11-8).
Serial Command
# Indicates a numeric entry
MNUCDP
MNUCDS
DEFALT
PAP_AT
PAPLTD
PAP232
PAPP5B
PAP9B1
PAPP17
PAP9B2
RTLPDF1
RTLPDF0
RTLMPS
PAPSPH
PAPSPT
3-5).
Page
1-6
1-6
1-6
2-1
2-1
2-1
2-2
2-2
2-2
2-2
2-2
2-2
2-3
2-3
2-3
11 - 3
Hide quick links:
Advertisement
Table of Contents
