Character Deactivation Mode; Deactivation Character; D/E Character (Disable/Enable) - Honeywell ORBIT 7120PLUS User Manual

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the following On
bar code to use character deactivation, then use Deactivation Character (following)
to select the character you will send from the host to terminate scanning. Default =
Off.

Deactivation Character

This sets the character used to terminate scanning when using Character Deacti-
vation Mode. On the
hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then scan the alphanumeric combination that rep-
resents that ASCII character from the
Scan

D/E Character (Disable/Enable)

If you want to enable scanning by sending an E serial command, and disable scan-
ning by sending a D, scan the D/E Character On bar code that follows. Scan the D/
E Character Off bar code to turn this feature off. Default = D/E Character Off.
48
* Off
ASCII Conversion Chart (Code Page
Save to finish. Default = 14 [DC4].
*D/E Character Off
Programming Chart,
Deactivation Character
Orbit 7120plus/7190g User Guide
On
1252), page 214, find the
beginning on page 225.
D/E Character On