Remote Control - Luxman L-550AXII Owner's Manual

7. Subsonic switch (SUBSONIC)
Cuts ultra-low frequencies out of audible range to pre-
vent ultra-low range noise from adversely affecting audible
range. This function is significantly effective especially when
an analog record is warped or a woofer is shaking owing to
ultra-low range vibration.
• This switch toggles the subsonic on and off.
The subsonic indicator lights up when the subsonic switch
is on.
* When the line straight switch is set to on, this switch does
not function.
8. Loudness switch (LOUDNESS)
Corrects the characteristics of human ears that causes dif-
ficulty in listening to low-pitched and high-piched sounds
when the sound volume is low.
• This switch toggles the loudness on and off.
The loudness indicator lights up when the loudness switch
is on.
* When the line straight switch is set to on, this switch does
not function.
9. Line straight switch (LINE STRAIGHT
Enhances the purity of the sound quality by bypassing the
balance control circuit, tone control circuit, or the like.
off (line straight indicator off): Line straight off/bypass off
on (line straight indicator on): Line straight on/bypass on
• This switch toggles the line straight on and off.
The line straight indicator lights up when the line straight
switch is set to on.
10. CD/SACD player operation switch
(CD/SACD PLAYER)
This switch is used to control the corresponding CD/SACD
players.
The corresponding CD/SACD players are the following
10 models: D-08u, D-06u, D-05u, D-08, D-06, D-05, D-10,
D-7, D-600, and D-700S as of April 2016.
11. Volume control switches
(VOLUME, i, o)
Adjusts the sound volume.
• Pressing i increases the sound volume in steps of 1 dB.
• Pressing o decreases the sound volume in steps of 1 dB.

Remote control

The remote control shall be aimed at the remote sensor of
this unit within the specified angle range shown in the illus-
tration.
)
Dry cell
[How to load dry cells]
1. Put your finger on the battery cover claw on the rear of the
remote control, and slide the cover downward to open it.
2. Put 2 AAA batteries in the battery case as shown in the illus-
tration.
3. Close the battery cover.
* When the batteries start to lose power, the effective dis-
tance becomes shorter or the unit does not function even
though the switch is pressed. In such a case, both of the
batteries should be replaced with new ones at the same
time.
* If the remote control is not used for a long time, the batter-
ies should be removed from the case.
INTEGRATED AMPLIFIER L-550AX
30° 30°
Effective distance:
approx. 5 meters
Ⅱ
19