Location Of Power Supply; Power Supply Cables - HP ProLiant DL100 G2 Administration Manual

Figure 63 Location of power supply
To remove a power supply:
1. Remove the rear top cover (see
2. Unplug the power supply cables connected to the backplane.
Figure 64 Power supply cables
P1 Main power connector
P2 Processor power connector
P3 Backplane power connector
3. Remove the four screws securing the power supply to the chassis.
126
Troubleshooting, servicing, and maintenance
"Rear top cover" on page 121).
P4 Not used
P5/P6 Hard disk drive power connectors