Backplane Battery; Tighten Rear Top Cover Screw; Backplane Battery Location; Removing Backplane Battery - HP ProLiant DL100 G2 Administration Manual

Figure 54 Tighten rear top cover screw

Backplane battery

CAUTION:
Remove power to the server by disconnecting the power cord before removing or installing the backplane
battery.
Refer to Figure 55
Figure 55 Backplane battery location
To remove the backplane battery:
1. Remove the rear top cover (see
2.
Pull the battery retaining clip away from the battery.
Figure 56 Removing backplane battery
3. Lift the battery on the lever side and pull it out of the holder.
122
Troubleshooting, servicing, and maintenance
for the location of the battery on the backplane.
"Rear top cover" on page 121).