Adjustment Procedures; Preparation - Icom IC-F14 Service Manual Addendum

SECTION 5.

5-1 PREPARATION

¤ REQUIRED EQUIPMENTS
EQUIPMENT
Adjustment
"CS-F14 ADJ" (Revision 1.0 or later)
Software
Frequency range
Audio Generator
Output level
Measuring range
RF Power Meter Frequency range
(terminated type) Impedance
SWR
Frequency range
Frequency Counter Frequency accuracy : ±1 ppm or better
Input level
Modulation Frequency range
Analyzer Measuring range
SYSTEM REQUIREMENTS
® ®
• Microsoft Windows 98/SE/ME/2000/XP
• RS232C/USB port
BEFORE STARTING SOFTWARE ADJUSTMENT
Clone adjustment freqencies, TX power, CTCSS frequency,
DTCS code and IF bandwidth into the transceiver using with
the CS-F14
CLONING SOFTWARE
See the next page for detail.
CAUTION!:
BACK UP the originally programmed memory
data in the transceiver before programming
the adjustment frequencies.
When program the adjustment frequencies
into the transceiver, the transceiver's memory
data will be overwritten and lose original
memory data at the same time.
Microsoft, Windows and Windows Vista are either registered
trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
ADJUSTMENT PROCEDURE
SPECIFICATION
: 300–3000 Hz
: 1–500 mV
: 1–6 W
: 100–300 MHz
: 50 Ω
: Less than 1.2 : 1
: 0.1–300 MHz
: Less than 1 mW
: 30–300 MHz
: 0 to ±10 kHz
before starting adjustment.
EQUIPMENT
JIG cable Modifi ed OPC-478U/UC (USB type) or
(see the page 5-3) OPC-478 (RS-232 type)
Power attenuation : 30 dB
Attenuator
Capacity
Frequency range
Standard Signal
Output level
Generator (SSG)
AC Millivoltmeter Measuring range
Frequency range
Oscilloscope
Measuring range
Input impedance
External Speaker
Capacity
5 - 1
SPECIFICATION
: More than 6 W
: 0.1–300 MHz
: 0.1 mV to 32 mV
(–127 to –17 dBm)
: 10 mV to 10 V
: DC–20 MHz
: 0.01–20 V
: 8 Ω
: More than 5 W