Adjustment Procedures; Initial Set Mode; Entering Initial Set Mode; Selection Method - Icom IC-F1010 Service Manual

5.1 INITIAL SET MODE
The following items can be adiusted via lnitial set Mode
without opening the transceiver's case'
I ENTERING INITIAL SET MODE
OTurn the transceiver Power OFF
@While pushing @ and Fl , turn power ON
r Bank number appears
regardless of the channel
separation type,'bank'
or'free.'
@Push @
,o cycle through the initial set mode items.
NOTE: Initial set Mode access can !e inhibited through
PC programming. In such cases, [Fol cannot be used
and only 'DISPIAY' setting can be done' Ask your
Dealer or lcom Service Center for PC programming.
Bank number
f t',c
F -
LInn
I SELECTABLE ITEMS
No. ITEM
SELECTABLE CONDITIONS
@ @
@
1
DISPLAY Backlight
Contrast
2 AF/SOUELCH
Squelch
level
Minimum
AF level
3 BEEPTONES
Link
ON/OFF
Beep tones
ON/OFF
Beep level
4
DEVIATION
DTCS
balance
Tone
deviation
Max. voice
deviation
5 S.METER
Indicate the received signal level
regardless of [P1] to [P3] keys
6
TX POWER
Low 1 Low 2 High
I SELECTION METHOD
MODE
No.
ITEM
METHOD
NOTE
I
I
Display backlight
Push [Pr ] to select 'dark' or 'bright.'
Display Contrast
Rotate the volume control while pushing (F).
;,
Squelch level
Rotate the volume control while pushing (E).
Minimum AF level
Rotate the volume control while pushing (El'
l
Link/unlink beep tones
with the volume control
Push @, o
s e l e ct' l i n k' o r ' u n l i n k .'
2 beeps: link; 1 beep: unlink
Beep ON/OFF
Push @
t" turn beep ON and OFF.
2 beeps: ON
1 beep: OFF
Effective after exiting Initial Set Mode
Maximum beep level
Rotate the volume control while pushing [El,
Ll
DTCS balance
Rotate lhe volume control while pushing [Fil.
Automatic transmission while pushing the key.
CTCSS/DTCS
Tone deviation
Rotate the volume control while pushing [FIl.
Automatic transmission while pushing the key.
Separate setting for CTCSS and DTCS
deoendino on the oroorammed tone system,
Maximum voice deviation
Rotate the volume control while pushing (E ).
Automatic transmission while pushing the key.
5
S-meter level
Received signal level is shown in the display.
fi
Transmit low Power (L1)
Rotate the volume control while pustring (El.
Automatic transmission while pushing the key.
Transmit low power (L2)
Rotate the volume control while pushing [El.
Same as above.
Transmit high power (H)
Rotate the volume control while pushing [F[]'
Same as above.
5 - 1