Icom IC-F14 Service Manual Addendum page 24

Analog portables vhf/uhf
Hide thumbs Also See for IC-F14:
Table of Contents

Advertisement

SECTION 1.
GENERAL
• Frequency coverage
• Mode
• Channel spacing
• Number of conventional channels
• Antenna impedance
• Operating temperature range
• Power supply requirement
• Current drain (at 7.2 V DC ; approx.)
• Dimensions (projections not included)
• Weight (Including BP-231)
TRANSMITTER
• Output power (at 7.2 V DC)
• Modulation
• Maximum permissible deviation
• Frequency error
• Spurious emissions
• Adjacent channel power
• Audio harmonic distortion
• Hum and Noise ([F14/S, F16/S, F3018]) : 40 dB min. (46 dB typ.) for Wide
(without CCITT filter)
• Residual modulation ([F15/S])
(with CCITT filter)
• Limiting charact of modulator
• Microphone impedance
RECEIVER
• Receive system
• Intermediate frequencies
• Sensitivity
• Adjacent channel selectivity
• Spurious response
• Intermodulation rejection ratio
• Hum and Noise ([F14/S, F16/S, F3018]) : 40 dB min. (50 dB typ.) for Wide
(without CCITT filter)
• Hum and Noise ([F15/S])
(with CCITT filter)
• Audio output power
• Squelch sensitivity (at threshold)
• Output impedance (Audio)
Specifications are measured in accordance with EIA-152-C/204D, TIA-603 or EN 300 086.
All stated specifications are subject to change without notice or obligation.
SPECIFICATIONS
: 136.000–174.000 MHz
: FM
: (Refer to the "INTRODUCTION")
: 16 ch/2 ch (Refer to the "INTRODUCTION")
: 50 Ω
: –30˚C to +60˚C (–22˚F to +140˚F)
–25˚C to +55˚C
: Specified Icom's battery pack only (7.2 V DC nominal; negative ground)
:
RECEIVING
Stand-by
Max. audio
70 mA
300 mA
: 53(W)×120(H)×38(D) mm; 2
: Approx. 260 g (9
3
)
16 oz
: 5 W
: Variable reactance frequency modulation
: ±5.0 kHz (Wide), ±4.0 kHz (Middle), ±2.5 kHz (Narrow)
: ±2.5 ppm
: 80 dB (typical)
0.25 µW (≤ 1 GHz), 1.0 µW (> 1 GHz)
: 70 dB min. (80dB typ.) for Wide and Middle
60 dB min. (70dB typ.) for Narrow
: 3% typical (1 kHz, 40% deviation)
34 dB min. (40 dB typ.) for Narrow
: 45 dB min. (55 dB typ.) for Wide
43 dB min. (53 dB typ.) for Middle
40 dB min. (50 dB typ.) for Narrow
: 60–100% of maximum deviation
: 2.2 kΩ
: Double conversion superheterodyne system
: 1st IF: 46.35 MHz, 2nd IF: 450 kHz
: 0.25 µV (–119 dBm) typical at 12 dB SINAD
–4 dBµ (–111 dBm) emf typical at 20 dB SINAD [F15/S]
: 70 dB min. (75 dB typ.) for Wide and Middle
60 dB min. (65 dB typ.) for Narrow
: 70 dB min.
: 70 dB min. (74 dB typ.)
65 dB min. (67 dB typ.)
34 dB min. (45 dB typ.) for Narrow
: 45 dB min. (55 dB typ.) for Wide
43 dB min. (53 dB typ.) for Middle
40 dB min. (50 dB typ.) for Narrow
: 0.5 W typical at 5% distortion with an 8 Ω load
: 0.25 µV typical
–4 dBµV emf typical
: 8 Ω
1 - 1
[F14/S, F16/S, F3018]
[F15/S]
TRANSMITTING
High (at 5 W)
Low (at 1 W)
1.5 A
0.7 A
3
23
1
(W)×4
(H)×1
(D) in
32
32
2
[F14/S, F16/S, F3018]
[F15/S]
[F14/S, F16/S, F3018]
[F14/S, F16/S, F3018]
[F15/S]
[F14/S, F16/S, F3018]]
[F15/S]

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ic-f15sIc-f14sIc-f16Ic-f16sIc-f3018Ic-f15

Table of Contents