Faults And Self-Help With Troubleshooting - Swisscom Aton CL117 Operating Instructions Manual

Faults and self-help with troubleshooting

Not every problem signifies a fault in your telephone. In some cases, problems can be resolved
by briefly interrupting the power supply to the base station (unplug the power supply unit and then
plug it in again) or removing the battery cells from the handset and reinserting them. The
following information is designed to help you with specific problems.
Important:
R Some problems or faults can only be resolved if you take the complete device (base station,
handset and connection cable) to the place of purchase.
Error messages
Display message
*1
BS kein Strom
or
Keine Verb.
Netzteil erneut
anschl.
or
Keine Verbind.
Telefonverb. prüfen
Speicher voll
Akkus benutzen
Bitte die Rufnr.
Anzeige bestellen !
*1 "BS" in display message represents base unit.
ATON_CL117(en-de)_0819_ver012.pd37
Cause/solution
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 29).
R When "Keine Verbind." is displayed during a power
failure, place a handset on the base unit to supply power to
the base unit.
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
R The phonebook memory is full. Erase unwanted entries
(page 19).
R The call barred list memory is full. Erase unwanted entries
(page 28).
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 7.
R Once you receive caller information, this message will not be
displayed.
37
Useful Information
2014/08/19 17:25:22
37