Caller Id Service; Using Caller Id Service; Caller List - Swisscom Aton CL117 Operating Instructions Manual

Using Caller ID service

Caller ID features
Note:
R In the Swisscom network CLIP is
transmitted automatically.
When an outside call is being received, the
caller information is displayed.
Caller information for the last 50 callers is
logged in the caller list from the most recent
call to the oldest.
R If the unit cannot receive caller information,
the following is displayed:
– "Dienst ni.vorh."/"Dienst nicht
*1 : The caller dials from an area
vorh."
which does not provide a Caller ID
service.
– "Nr. unterdr."/
"Nummer unterdr."
requests not to send caller information.
R If the unit is connected to a PBX system,
caller information may not be properly
received. Contact your PBX supplier.
*1 Shown while viewing the caller list.
Missed calls
If a call is not answered, the unit treats it as a
missed call and is displayed. This lets you
know if you should view the caller list to see
who called while you were away.
Even if only one missed call in the caller list is
viewed (page 31), disappears from the
display. When you receive another new call,
is displayed again.
Note:
R Even when there are unviewed missed
calls, disappears from the standby
display if the following operation is
performed by one of the registered
handsets:
– Being replaced on the base unit or
charger.
– Pressing MeN.
ATON_CL117(en-de)_0819_ver012.pd31
Phonebook name display
When caller information is received and it
matches a phone number stored in the
phonebook, the stored name in the
phonebook is displayed and logged in the

caller list.

Caller list
Important:
R Only 1 person can access the caller list at a
time.
R Make sure the unit's date and time setting
is correct (page 13).
Viewing the caller list and calling
back
*1 1
: The caller
2
3
Note:
R If the entry has already been viewed or
answered, " " is displayed, even if it was
viewed or answered using another handset.
R If the call matches an entry in the call
barred list, the number is logged with
(page 27).
Using the Smart-Taste
When
flashes slowly, there are missed calls.
Press M
list and calling back", page 31.
R "Entgangener Anruf" must be set to
"On" in "Setting the Smart-Taste", page 14.
31

Caller ID Service

MCN ( )
Press MCN to search from the most recent
call, or press MDN to search from the
oldest call.
R If is displayed, not all of the
information is shown. To see the
remaining information, press MEN. To
return to the previous screen, press
MFN.
To call back, press M N.
To exit, press MeN.
is displayed and the NR indicator
N in step 1 on "Viewing the caller
2014/08/19 17:25:21
31