Figure 3-6 Changing Parameters Via The Op - Siemens micromaster 410 Operating Instructions Manual

3 Commissioning
Changing parameters with the Operator Panel
The procedure for changing the value of parameter P0004 is described below.
Modifying the value of an indexed parameter is illustrated using the example of
P2011. Follow exactly the same procedure to alter other parameters that you wish
to set via the OP.
Changing P0004 – parameter filter function
1
Press
2
Press
3
Press
4
Press
5
Press
6 Only the motor parameters are visible to the user.
Changing P2011 an indexed parameter
Setting USS address
1
Press
2
Press
3
Press
4
Press
5
Press
6
Press
7
Press
Press
8
drive display (as defined by the customer)
Figure 3-6
38
Step
to access parameters
until P0004 is displayed
to access the parameter value level
or to the required value
to confirm and store the value
Step
to access parameters
until P2011 is displayed
to access the parameter value level
to display current set value
or to the required value
to confirm and store the value
until r0000 is displayed
to return the display to the standard
Changing parameters via the OP
Result on display
Result on display
MICROMASTER 410 Operating Instructions
6SE6400-5EA00-0BP0
Issue 04/02