To Save Traces And Setups To A New File On The Floppy Disk - Agilent Technologies 54621A User Manual

To save traces and setups to a new file on the floppy disk

1 To create a new file name, press the
If you do not want to overwrite an existing file, use this menu to enter a new
file name. New file names can be up to eight characters long. New file names
can only be written to the floppy disk, not the internal memory.
2 Turn the Entry knob to select the first character in the file name.
Turning the Entry knob selects a character to enter into the highlighted position
shown in the "New file name =" line above the softkeys and in the Spell
softkey.
3 Press the softkey to enter the selected character and go to the next
Enter
character position.
You may position the highlight on any character in the file name by successively
pressing the Enter softkey.
4 To delete a character from the file name, press the
the letter you want to delete is highlighted, then press the
softkey.
5 When you are done entering characters for the file name, press the
softkey to save the file.
Press to Save
Two files will be saved to the floppy disk. In the example above, SCOPE1.TRC
will be the trace file and SCOPE1.SCP will be the setup file. You do not need
to remember these file extensions because you can select trace, setup, or both
when you recall this information using the Recall menu.
MegaZoom Concepts and Oscilloscope Operation
To save traces and setups to a new file on the floppy disk
New File softkey.
softkey until
Enter
Delete Character
4-51