Front-Panel Overview
To modify the display grid
To modify the display grid
1 Press the
Display
key.
2 Turn the Entry knob to change the intensity of the displayed grid. The
intensity level is shown in the
100%.
Each major division in the grid (also know as graticule) corresponds to the
sweep speed time shown in the status line on the top of the display.
• To change waveform intensity, turn the
lower-left corner of the front panel.
To print the display
You can print the complete display, including the status line and softkeys, to a
parallel printer or to the floppy disk by pressing the Quick Print key. You can
stop printing by pressing the Cancel Print softkey.
To set up your printer, press the Utility key, then press the Print Confg softkey.
For more information on printing and floppy disk operation, refer to the
"Utilities" chapter.
2-24
softkey and is adjustable from 0 to
Grid
INTENSITY
knob on the