Declaration Of Conformity; Troubleshooting - Bosch AMW SG Original Instructions Manual

OBJ_BUCH-1676-003.book Page 11 Thursday, September 22, 2016 4:07 PM
Please take care to place down the pole pruner with the oil filler
cap facing upward.
When storing in the sales packaging, the oil reservoir must be
completely emptied.
 Do not modify this product. Unauthorized modifications
may impair the safety of your product and may result in in-
creased noise and vibration.
Technical Data
Pole Pruner Attachment
Article number
Chain bar length
Chain speed (no-load)
Chain, width
Oil tank volume
Weight according to EPTA-
Procedure 01:2014
without power unit
Serial number

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical data" in combination with power unit
AMW 10 (3 600 HA3 0..) is in conformity with the following
standards or standardization documents: EN 60335,
EN ISO 11680-1, EN 50581 according to the provisions of the
directives 2011/65/EC, 2014/30/EU, 2006/42/EC,
2000/14/EC.
2000/14/EC: Guaranteed sound power level 107 dB(A).
Equipment category: 25
Technical file (2006/42/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ECS
Robert Bosch Power Tools GmbH
70538 Stuttgart, GERMANY
Stuttgart, 01.01.2017

Troubleshooting

Problem Possible Cause
Saw chain dry No oil in reservoir
Oil passage clogged
Saw chain/guide bar hot No oil in reservoir
Chain tension too high
Dull saw chain
Bosch Power Tools
Noise/Vibration Information
The following information is applicable for the attachment oper-
ated by the power unit:
Measured sound values determined according to
EN ISO 11680.
Typically the A-weighted noise levels of the product are: Sound
pressure level 84.5 dB(A); sound power level 104.5 dB(A). Un-
certainty K =2.5 dB.
Vibration total values (triax vector sum): Vibration emission val-
ue a
AMW SG
0 600 8A3 B..
Mounting and Operation
mm 300
m/s 12
Action
mm 1.3
Delivery Scope
ml 150
Open cover
Assemble / tension saw chain
Fitting the multi-tool attachmentt
kg 1.55
Filling oil
see type plate on the gar-
Working Advice
den product
Storage
Selecting Accessories
Unfasten the locking knob on cover.
Turn the chain locking screw in housing next to the chain bar
clockwise to tension and anti-clockwise to loosen the saw chain.
The saw chain is correctly tensioned, if on top it can lifted off
2 –3 mm.
Tension the locking knob. Pull the chain in reverse with your
hand. The saw chain must glide easily on the chain bar but not be
too loose off the bar.
2
= 4.5 m/s , Uncertainty K= 2.5 dB.
h
Tension saw chain
Corrective Action
Refill oil
Clean oil passage
Refill oil
Tension saw chain
Sharpen saw chain or replace
English | 11
Figure
1
2
3
4
5
6
7
8
F 016 L81 466 | (22.9.16)