Battery Mode; Eco Mode; Setup Mode - Delta UPS602N2004N035 User Manual

6.4 Battery Mode

When the UPS is operating during a power outage, the batteries provide DC power,
which maintains inverter operation to supply power to the connected critical loads.
NOTE :
For models UPS602N2004N035 (6 kVA ) & UPS103N2004N035 (10 kVA )
& UPS602N2004N0BA (6kVA) & UPS103N2004N0BA (10kVA):
You can install the UPSentry 2012 software (please download from
http://www.deltapowersolutions.com/en-in/mcis/software-center.php) or
the SNMP card (optional) or the ModBus card (optional) to monitor and
estimate the battery remaining capacity before or during an AC power
failure. For more information about the SNMP card (optional) or the
ModBus card (optional), please refer to its user manual.
For models UPS602N2004N0B0 (6 kVA ) & UPS103N2004N0B0 (10 kVA ):
You can install the UPSentry 2012 software (please download from http://
www.deltapowersolutions.com/en-in/mcis/software-center.php) or the mini
SNMP card (optional) or the mini ModBus card (optional) to monitor and
estimate the battery remaining capacity before or during an AC power
failure. For more information about the mini SNMP card (optional) or the
mini ModBus card (optional), please refer to its user manual.

6.5 ECO Mode

You can manually set the UPS to run in ECO mode. In ECO mode, when the
frequency is within the range of rated frequency ±5Hz, the connected loads are
supplied by the bypass power; if out of the range, the connected loads are supplied
by the inverter.

6.6 Setup Mode

mode, you can set up the following items:
1. Inverter voltage setup
2. Inverter frequency setup
Chapter 6
35
Operation Modes