Pid Control Input (Un-15); The Output Terminal Status While Last Fault Occurred (Un-29); The Cumulative Time Whenever The Input Power Is On (Un-30); Motor Speed While Pg Feedback Is Set. (Un-33) - TECO speecon 7200ma Instruction Manual

(13)PID Control Input
(14)PID Control Output1 (Un-16)
(15)PID Control Output2 (Un-17)
•The values in Fig. 14 (on page 42) can be monitored through the parameters of
Un-15, Un-16 and Un-17. Moreover, the multi-function analog output terminal
AO1, AO2 can be used to monitor the output value through the proper setting of
Sn-33 and Sn-34.
(16)Message 1
(17)Message 2
(18)Message 3
(19)Message 4
•These parameters are used to display the fault messages whenever the fault
occurred. The user can take proper action for trouble-shooting based upon the
displayed message.
(20)The Cumulative Operation Time Setting
•The parameter is used to count the elapsed time from the previous fault to the
latest fault occurred recently. Its setting range is 0~65536 Hr. After the fault have
been cleared and system reset again, the Un-22 will be cleared to zero and counted
again.
(21)The Frequency Command While Last Fault Occurred (Un-23)
(22)The Output Frequency While Last Fault Occurred
(23)The Output Current While Last Fault Occurred
(24)The Output Voltage While Last Fault Occurred
(25)The DC Voltage While Last Fault Occurred
(26)The Input Terminal Status While Last Fault Occurred (Un-28)

(27)The Output Terminal Status While Last Fault Occurred (Un-29)

•The above parameters will display the inverter status when the fault occurred
lately. The contents of parameters Un-15~21 will be cleared after the faults have
been cleared and the system reset again.
(28)The Cumulative Time Whenever The Input Power Is On
•The parameter will record the cumulative operation time from power-on to power-
off. Its value is 0~65536 Hr. If the value exceed 65536, it will restart from 0 again.
(29)The Cumulative Run Time Whenever The Output Power Is On (Un-31)
•The parameter will record the cumulative operation time from power-on to power-
off. Its value is 0~65536 Hr. If the value exceeds 65536, it will restart from 0
again.
(30)The EPROM Software Version
•The parameter will specify the updated software version in this 7200 MA inverter.

(31)Motor Speed While PG Feedback Is Set. (Un-33)

•While PG feedback control is set, The motor speed can be monitored through Un-33.
(Un-15)
(Un-18)
(Un-19)
(Un-20)
(Un-21)
(Un-22)
(Un-32)
103
(Un-24)
(Un-25)
(Un-26)
(Un-27)
(Un-30)