System Mode - SATO WS4 Series Operator's Manual

1 Introduction

1.4.2 System Mode

The system mode consists of status light color combinations. It contains a
list of commands for you to select and run.
To enter the system mode and run the command, do the following:
1. Turn off the printer.
2. Press and hold the FEED button and turn on the printer.
3. Both status lights illuminate solid orange for a few seconds. Next, they
turn to green shortly and then turn to other colors.
4. When status lights show the color combination you need, release the
FEED button immediately.
5. Press the FEED button to run the command.
The following table is the command list of the system mode.
LED 1
Green
Green
Red
Red
Orange
Orange
LED 2 Command
Red Transmissive Sensor Calibration
Orange Reflective Sensor Calibration
Red Reset Your Printer
Orange Reserved
Red Reserved
Green Self-Test
12
Printer Lights