Canon IMAGERUNNER 5075 Reference Manual page 128

■ Insertion Unit
When the Cover/Sheet Insertion, Cover/Job Separator, or Booklet (Saddle Stitch Booklet)
mode has been set, the document insertion unit feeds the sheets to make a cover. The
document insertion unit is necessary to feed paper which cannot be fed from the main unit
or paper deck (paper which has been color copied, etc.), for use as a cover.
IMPORTANT
•
This section assumes that the optional Document Insertion/Folding Unit-F1 or Document
Insertion Unit-E1 is attached to the optional Finisher-AD1 or Saddle Finisher-AD2.
•
Paper which has been rolled or curled must be straightened out before placing it into the
document insertion unit.
•
3 Do not place the following types of paper into the document insertion unit. Doing so may
cause a paper jam.
- Insertion sheets with holes or tears
- Severely curled or wrinkled paper
- Tab paper
- Clipped or stapled insertion sheets
- Transparencies or other highly transparent insertion sheets
- Tracing paper
- Labels
■ Document Insertion Unit Staple Settings and Output Results Table
3-26
Finisher-AD1/Saddle Finisher-AD2/Puncher Unit-AT1/Document Insertion/Folding
Unit-F1/Document Insertion Unit-E1
How to Place the Cover Sheet/Original
Document
Feeder
Insertion Unit
ABC
Staple
Platen
Settings
Glass
Corner: Upper Left
C B A
Double: Left
Corner: Lower Left
Double: Left
11" ✕ 17"
Corner: Upper Right
LGL
Double: Right
Corner: Lower Left
Double: Left
Corner: Upper Right
Double: Right
Output
Result
ABC
ABC
LTR
ABC
ABC
11" ✕ 17"
ABC
ABC
LTR