Table of Contents
Advertisement
Power LED
DP2 is an Onboard Power LED. When
this LED is lit, it means power is present
on the serverboard. Be sure to turn off the
system and unplug the power cord(s) before
removing or installing components.
UID LED (LE1)
A rear UID LED Indicator, located at LE1,
works in conjunction with the rear UID switch
to provide easy identification for a unit that
might be in need of service. Refer to Page
2-13 for further UID details.
5-11 SATA Drive Connections
SATA Ports
There are no jumpers to configure the SATA
ports, which are designated SATA0 through
SATA3. See the table on the right for pin
definitions.
Chapter 5: Advanced Motherboard Setup
State
On
Off
Pin # Definition
1
2
3
4
5
6
7
5-21
Power LED
(DP2)
System Status
Standby power present
on motherboard
No power connected
SATA Ports
Pin Definitions
(SATA0-SATA3)
Ground
TXP
TXN
Ground
RXN
RXP
Ground
Advertisement
Table of Contents
