Table of Contents
Advertisement
3. Install a new drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
4. Secure the hard drive by tightening all six (6) screws (see Figure 6-19).
SATA Hard Drive
2
4
Drive Tray
5. Use the open handle to replace the drive tray into the chassis. Make sure the
close the drive tray handle.
Note! Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at http://www.supermicro.com/products/nfo/storage.cfm.
6-10 Power Supply
Depending on your chassis model, the SC827 chassis includes two 1400 Watt
power supplies. This power supply is auto-switching capable. This enables it to
automatically sense and operate at a 100v to 240v input voltage. An amber light
on the power supply is illuminated when the power is off. A green light indicates
that the power supply is operating.
Figure 6-19. Installing the Hard Drive
6-17
Chapter 6: Advanced Chassis Setup
1
4
Advertisement
Table of Contents
