5-11 Sata Drive Connections - Supero SUPERSERVER 1027R-WRF User Manual

Rear UID LED
The rear UID LED is located at LED3 on
the rear of the motherboard. This LED
is used in conjunction with the rear UID
switch to provide easy identifi cation
of a system that might be in need of
service. Refer to UID Switch on Page
2-17 for more information.
BMC Heartbeat LED
A BMC Heartbeat LED is located at
DM1 on the motherboard. When DM1
is blinking, BMC functions normally. See
the table at right for more information.

5-11 SATA Drive Connections

SATA/SC8U Ports
T h e r e a r e s i x S e r i a l ATA p o r t s
(I-SATA0~I-SATA 5) located on the
motherboard, including four SATA2
ports and two SATA3 ports. There are
also four SCU ports (SCU 0~3) located
on the X9DRW-iF. These ports provide
serial-link signal connections, which are
faster than the connections of Parallel
ATA. See the table on the right for pin
defi nitions.
Note: For more information on SATA HostRAID configuration, please
refer to the Intel SATA HostRAID User's Guide posted on our Website @
http://www.supermicro.com.
Chapter 5: Advanced Serverboard Setup
Color/State
Blue: On
Blue: On
BMC Heartbeat LED
Color/State Defi nition
Green:
Blinking
Pin Defi nitions
Pin#
1
2
3
4
5
6
7
5-29
UID LED
Status
Status
Unit Identifi ed
Unit Identifi ed
Status
BMC: Normal
SATA/SCU
Defi nition
Ground
TX_P
TX_N
Ground
RX_N
RX_P
Ground