Table of Contents
Advertisement
InfiniBand Port Enable/Disable
(H8DCT-IBQF only)
JIB1 enables or disables the InfiniBand port
on H8DCT-IBQF serverboard. The default
position is on pins 1 and 2 to enable the
port. See the table below for jumper settings.
I2C to PCI-Express Slots
JI
C1/JI
C2 slots allows you to enable the I
2
2
bus to communicate with a PCI-Express slot.
For the jumpers to work properly, please set
both jumpers to the same setting. If enabled,
both jumpers must be enabled. If disabled,
both jumpers must be disabled. See the table
on the right for jumper settings.
BMC Jumper
JPB1 is used to enable or disable theBMC
(Baseboard Management Control) Chip and
the onboard IPMI connection.This jumper is
used together with the IPMI settings in the
BIOS. The default position is on pins 1 and
2 to Enable BMC. See the table on the right
for jumper settings.
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on the
right for jumper settings.
LAN Enable/Disable
Change the setting of jumper JPL1 to enable
or disable the LAN1/2 Ethernet ports. See
the table on the right for jumper settings. The
default setting is enabled.
Chapter 5: Advanced Motherboard Setup
Jumper Enable (JIB1)
Jumper Setting
Pins 1-2
Pins 2-3
I
C to PCI-Express Slot
2
C
2
Jumper Setting
Closed
Open
BMC Jumper Enable
Jumper Setting
Pins 1-2
Pins 2-3
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
LAN Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
5-19
InfiniBand Port
Jumper Settings
Definition
Enabled
Disabled
Jumper Settings
(JI
C1/JI
C2)
2
2
Definition
Enabled
Disabled
(JPB1)
Jumper Settings
Definition
Enabled
(default)
Disabled
Definition
Enabled
Disabled
(JPL1)
Definition
Enabled
Disabled
Advertisement
Table of Contents
