Main Dryer - Electrolux T5190LE Service Manual

Service Manual
86

MAIN DRYER

15:2 UNLOADING DOOR OPEN
Only on Pocket washer:
This error code will be shown if the control system detects that the input DOOR CLOSED 2 (unloading side) has been
deactivated during an on-going program.
The error can only occur during an on-going program.
Possible causes:
This can be caused by for example a bad or defective door lock, loose cable to door lock, problem with door lock
edge connection, defective input on I/O unit type 10 etc.
Recommended action:
1. Check door lock functionality in service program, but activating door lock and then by checking inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock to locate intermittent errors.
15:3 UNLOADING DOOR NOT LOCKED
Only on Pocket washer:
This error code will be shown if the control system detects that the input DOOR LOCKED 2 has not been activated
within a certain time after unloading door is closed.
It will also be activated if the input DOOR LOCKED 2 has been deactivated during an on-going program.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock, loose cable connec-
tion to door lock, broken cables to door lock or mechanical problem with emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, but activating door lock and then by checking check inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
4. Check DLCU 2 status in service mode for more information on possible causes.
15:17 DOOR LOCK
Only on Pocket washer running with one door setup.
This error code is activated if the input for DOOR LOCKED 2 is active at program start, i.e. the door is locked
although the control system has not requested locking.
Possible causes:
• DLCU 2 is in error mode after previous program run.
• Door lock solenoid broken.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by checking check inputs.
2. Check DLCU 2 status in service mode for more information on possible causes.
3. If DLCU 2 is in error mode, wait five minuts for automatic reset or manually reset the DLCU 2 in service mode.