Electrolux T5190LE Service Manual page 83

Service Manual
83
13:6 DRUM LOCK POSITION SWITCH
The error code is shown if inputs DRUM UNLOCKED and DRUM LOCKED are both active or inactive at the same
time during program run. Since it occurs during program run it is required to turn power off to the machine to clear the
error message.
Possible causes:
Heavy unbalance in drum that prevents the motor to position the drum. Worst case scenario is wet load in one
compartment.
Could also depend on problems with indexing sensors, washer I/O board or malfunction in mechanical drum lock
function.
Recommended actions:
1. Check inputs from indexing sensors FC1 and FC2.
2. Run a positioning sequence with wet load in one compartment to test functionality.
13:7 DRUM NOT ROTATING
The error code is shown if positioning sensor on input on J201 is not indicating rotation when rotation is expected
during program run.
Recommended actions:
1. Check that drive belt is not broken.
2. Check positioning sensor on input J201.
13:8 UNBALANCE SWITCH ON AT PROG START
The error code is shown if unbalance switch is active at program start.
Recommended actions:
1. Check unbalance switch for proper alignment.
2. Check unbalance switch for electrical fault.
13:9 WATER IN DRUM - CALL SERVICE
This error code will be shown if the control system detects water above safety level when program is finished.
Possibly caused by broken inlet valve and / or drain valve.
Recommended actions:
1. Turn off water inlet to machine.
2. Manually open the drain valve.
3. Check reason for valve malfunction.
13:10 WATER IN DRUM - CALL SERVICE
This error code will be shown if the control system detects water above safety level in idle mode. Possibly caused by
broken inlet valve and / or drain valve.
Recommended actions:
1. Turn off water inlet to machine.
2. Manually open the drain valve.
3. Check reason for valve malfunction.