Pump Assembly - Mercury 305 CID Service Manual

Pump Assembly

IMPORTANT: Be careful to not cross-thread or
over-tighten hose fittings.
1. Be certain a new high pressure hose O-ring is
present, and install threaded fitting in back of
pump assembly. Tighten fitting securely. Connect
low pressure hose on back of pump. Tighten
hose clamp securely.
a
a - Pump
b - Bracket
c - Threaded Fitting
d - Low Pressure Hose
Index
9A-6 - POWER STEERING PUMP
b
c
72850
d
2. Install mounting hardware and fasteners to retain
pump to bracket. (Refer to "Exploded View" for
specific details on your engine.)
a
c
a - Screw With :Lockwasher
b - Nuts (With Hardware)
c - Spacers
3. Install drive belt and adjust tension. Refer to
"Pump Drive Belt Adjustment" as previously out-
lined.
4. Fill and air bleed system. Refer to Section 1B -
"Maintenance" (see "Table of Contents").
a
72849
b
72848
90-823225--1 1096