Gen Iii Cool Fuel Module Assembly; Top Cover And Fuel Pumps; Fuel Inlet Adapter Fitting - Mercury MerCruiser Service Manual

Gen III Cool Fuel Module Assembly and Installation
Lubricant, Sealant, Adhesives
Tube Ref No.

Gen III Cool Fuel Module Assembly

Fuel Inlet Adapter Fitting

1. Install the fuel filter assembly. Refer to Section 1B for filter installation procedure.
2. Hand thread the fuel inlet fitting adapter with pre-applied sealant into the Cool Fuel
3. Torque the fuel inlet adapter fitting to specification.
Overtightening the fuel inlet fitting can lead to fuel leaks, avoid severe personal injury or
death from a gasoline fire or explosion. Do not use a power tool (i.e. impact wrench) to
tighten the fuel inlet fitting.
Description
Fuel inlet fitting adapter

Top Cover and Fuel Pumps

1. Place the fuel pump outlet seals and isolators onto both fuel pumps.
2. Place the inlet seal for the low-pressure pump into the Cool Fuel Module housing.
Page 2B-2
Description
Loctite 567 PST Pipe Sealant
9
Module.
a - Fuel inlet fitting adapter.
Where Used
Fuel line inlet connector to adapter.
a
8269
WARNING
!
90-865376 NOVEMBER 2004
Part No.
92-809822
Nm lb. in. lb. ft.
22 16