A.2.2 Requirements For Mounting In A Third Party's Rack; Table A.3 Structural Condition Of Rack - Fujitsu PRIMEQUEST 2000 Series Hardware Installation Manual

APPENDIX A Racks

A.2.2 Requirements for mounting in a third party's rack

When mounting the PRIMEQUEST products in a rack manufactured by another company, customers need
to confirm on their own responsibility that the rack meets the PRIMEQUEST product specifications and
requirements.
Note
Fujitsu does not guarantee there will be no problems arising from the mounting of the PRIMEQUEST 2000
series server (including peripheral devices) in a rack manufactured by another company.
Examples: Cooling problem due to an insufficient supply of cooling air because of the rack structure, and
insufficient earthquake-resistance because the rack manufactured by another company is not strong enough
If mounting in a rack manufactured by another company cannot be avoided, confirm that the rack satisfies all
of the following structural requirements.
Number of Check
Length of rack
Check1 Allowable spacing between
posts
Check2 Length between front post and
rear cover
Check3 Length between front post and
front cover
Width of rack
Check4 distance between the left and
right posts (common to the
front and rear posts)
Check5 Distance between holes on the
left and right device mounting
posts (common to the front
and rear posts):
Check6 Bracket installation space
Format of rack
Check7 Pitch of hole
Check8 Format and size of hole
Check9 Cable takeout port
Check10 Loading Carrying Capacity of
rack
Check11 Open area ratio of rack
Check12 Measure to prevent the rack
from toppling

TABLE A.3 Structural condition of rack

Term
685 to 790mm
(26.7 to 31.1 in.)
860mm(33.9 in.) or more
60mm(2.4 in.) or more
450mm(17.7 in.) or more
465mm(18.3 in) or more
(EIA standard)
There must not be interference thing
(post for reinforcement or option) in
the shaded portion of figure.
EIA standard, universal pitch
Length of each side of a square hole:
9x9(0.35 in.) to 10x10 mm (0.39 in.)
The cable can be taken out of the
bottom or rear.
Total weight must be less than
loading Carrying Capacity of rack.
Note
Loading Carrying Capacity of rack
may change when anti-earthquake
measures are given.
Open area ratio of rack of front cover
and rear cover must be more than
60%.
Measure to prevent the rack from
toppling must be performed.
58
Condition Reference
FIGURE A.2
Length of rack
FIGURE A.2
Length of rack
FIGURE A.2
Length of rack
FIGURE A.3 Width
of rack
FIGURE A.4 Format
of rack posts
FIGURE A.3 Width
of rack
FIGURE A.4 Format
of rack posts
FIGURE A.3 Width
of rack
FIGURE A.4 Format
of rack posts
FIGURE A.4 Format
of rack posts
FIGURE A.2
Length of rack
-
-
-
CA92344-0535-06