User Parameters - GE Digital Energy SG 400 kVA Operating Manual

6.5

USER PARAMETERS

Pressing the Parameters button displays a series of screens containing the user parameters on the LCD
panel.
This first parameter level in not protected by password, therefore the user can freely adapt these
parameters to their needs.
The meaning of the user parameters and their use is described below (buttons performance is described
to Section 7.3).
1. Date and Time set-up
Date You can adjust the date of the real time clock existing in the UPS by the means of this
parameter.
The value you enter is thoroughly checked to be a correct date in the format "dd.mm.yy".
Time You can adjust the time of the real time clock existing in the UPS by means of this
parameter.
The value you enter is thoroughly checked to be a correct time in the format "hh.mm.ss".
The time is specified in 24-hour format.
2. Protocol Set-up
Modem enabled You can enable/disable with Y/N the remote control through modem calls by
using this parameter.
Init This parameter presents the modem initialisation string.
It can be 39 characters long.
When editing this parameter the UPS considers that a blank character terminates
the string.
If no blank character is found then all 39 characters are used.
Alarm This Y/N parameter controls the automatic events signalling through modem.
If this parameter is set to Yes the UPS itself will call the remote location when a
new event occurs.
Delay This parameter controls the delay between the occurrence of a new event and the
modem dialing.
It is useful because since the events typically do not occur isolated but in certain
sequences, you can eliminate the need for multiple dial-outs for such a sequence
of events.
Modifications reserved
OPM_SGS_USM_M40_M50_1US_V020.doc
DATE AND TIME
metering
D M Y
alarms
Date: 01.01.2006
Time: 12:45:07
parameters
m etering PROTOCO L SETUP
M odem enabled= N
alarm s
Init= BEQV1X3& D0S0=2
Alarm =N Delay=22sec
param eters
+
–
ok
+
–
ok
Operating Manual SG Series 400 & 500 kVA
Page 31/86