Miele Service - Miele PM 1210 Operating Instructions Manual

en-CA - Cleaning and care
The roller cover needs to be changed if
there is a visible gap on the lower edge of
the heater plate and roller (laundry infeed)
due to prolonged use.
Replacing the stainless wool padding on
the roller must only be carried out by

Miele Service.

The diameter of a new or re-upholstered
roller must not exceed the following di‐
mensions (including the roller cover).
PM 1210 / PM
1214:
min. 210 mm (ap‐
prox. 8.3 in.) - max.
215 mm (approx. 8.5
in.)
Within this range the roller should be wound
cylindrically over its entire length.
During the replacement of the roller pad‐
ding, Miele Service should check whether
the carbon brushes of the drive motor
need to be replaced as well.
Miele Service
In the event of a fault, contact Miele Serv‐
ice. Miele Service will require the model (M-
Nr) and serial number (SN).
This information can be found on the data
plate.
Use only genuine Miele spare parts for
replacement Miele Service will require the
model and serial number (SN) when order‐
ing.
20
PM 1217
min. 250 mm (ap‐
prox. 9.8 in.) - max.
255 mm (approx. 10
in.)