Roller Cover And Padding Instructions; Removing The Roller Cover; Fitting The Roller Cover - Miele PM 1210 Operating Instructions Manual

To wax the heater plate with the wax

cloth, sprinkle the wax into the pocket of
the wax cloth and close the pocket.
Use the wax sparingly to avoid the roller
cover becoming too smooth.
As soon as the right temperature has been

reached, the "Start" button starts to flash.
Press this button to start the waxing proc‐
ess.
Lay the pocket with the rubber-coated

side facing downwards (i.e., towards the
roller) and feed it into the warm machine
(heater plate temperature: approx. 180°C /
356°F).
Do not feed the wax cloth with the rub‐
ber-coated side facing upwards (i.e., to‐
wards the heater plate). It will damage the
roller padding!
Feed the wax cloth into the ironer from the

left or right at the necessary intervals
across the entire working width of the ma‐
chine.
To deactivate the function, press and hold

the "Clean / Wax"  button for longer
than 3 seconds.
Roller cover and padding instruc‐
tions
Turn off the rotary iron before removing the
roller cover (for cleaning or exchange) and
let the heater plate cool down.
en-CA - Cleaning and care

Removing the roller cover

Please note that the laundry pick-off
bands on the rollers need to be fully re‐
tracted one after the other.
Turn on the rotary iron using the "On / Off"

button .
Press and hold the "Maintenance posi‐

tion"  button for more than three sec‐
onds.
The heater plate lowers and is locked into
this position.
By repeatedly pressing the "Reduce tem‐

perature / Roller speed "  button, incre‐
mentally reverse the roller (jog mode).
Take the end of the roller cover and put it

on the laundry infeed table.
With the roller in reverse, now remove the

roller cover (jog mode).
Press and hold the "Maintenance posi‐

tion"  button for more than three sec‐
onds to deactivate the maintenance posi‐
tion.
Wire wool residues may fall onto the laundry
table whilst the roller cover is being taken
off. These must be removed.

Fitting the roller cover

Switch on the ironer at the lowest temper‐

ature and lowest speed by pressing the
"Start"  button.
During a normal ironing process, place the

roller cover on the ironer parallel to the
roller and feed the roller cover over the
roller.
19