Software Interface Sample: Mymaillist Ver. 1.9.7 - Rena envelope imager III Instruction Manual

Software interface sample:
Addresses may be printed on the Envelope Imager III using MyMailList.
After entering your data:
Press F3, the cursor will move into the Print Format window.
Select 3 1/2 x 15/16 labels
NOTE: MyMailList does not allow you to create a custom label size; therefore you
have two choices:
1.
35 characters per line.
2.
pauses the printer after each address.
Press F4, the cursor will move into the Print window.
Enter the Start and Stop Data as required.
Set ADDRESS SETUP on the Envelope Imager III to 6 lines.
Press F10 to Print.
MyMailList is set to print to whatever printer you have connected to Parallel Port #1 (LPT1). If
your Envelope Imager III is not connected to LPT1, press Ctrl-P to view the Printer Choice
Menu, and select the correct port.
User's Manual - Revision C
MyMailList ver. 1.9.7
1 label across
0 left margin
1 copy
3 1/2 x 15/16 labels - this limits you to 6 lines per address and
Envelope - this also limits you to 6 lines per address, and
Section F - 19
Appendix F Printing with Software