Table of Contents
Advertisement
INSTALLING THE UNIT
Select a suitable location for
secure installation of the unit.
• The unit must not distract the driver or
restrict the driver's view.
• The ability to enter and get out of the
vehicle must not be impeded.
• The unit must not be installed in such a
way that could prevent the other vehicle
components from functioning properly
(e.g. sliding sunroof).
• Make sure that the unit is installed in a
safe and secure position and that it cannot
become detached in the event of an
emergency stop.
• Do not attach the unit merely to the roof
liner.
• If you need to drill additional holes, make
sure you do not drill through the sheet
metal of the vehicle's roof.
• Avoid using the unit over a long period of
time while the engine is off in order to
prevent the battery from becoming
discharged.
9
Before starting work, disconnect the ground
cable from the vehicle battery's negative
terminal in order to prevent short circuits.
Note - follow the vehicle manufacturer's
safety instructions (alarm system, air bag,
immobilizer, etc.).
The unit must be installed horizontally (within
-10º to +30º of horizontal). A more severe
angle may prevent the unit from functioning
correctly.
The DVD system is attached via a mounting
plate. Depending on the installation, the
mounting plate can be attached to the
vehicle with self-tapping screws through any
of the 10 small slots in the plate. The DVD
system is then attached to the mounting
plate using five machine screws. Depending
on the thickness of the headliner, longer
self-tapping screws may also be used.
Check the screw length required prior to
final installation.
Advertisement
Table of Contents
