Connections - Blaupunkt IVOD-1002 User Manual

INSTALLATION
Marking the installation area.
1. Carefully pry the two transparent covers
of the interior lights off the unit from the
outside using a screwdriver. This allows
access to the two front mounting screw
holes.
2. Open the monitor display to access the
three rear mounting screw holes.
3. Hold the unit in the intended mounting
position and make five marks through the
screw holes.
4. Align the mounting plate with the five
mounting screw marks and trace suitable
drill hole marks through the small slots.
Attaching the unit.
1. Carefully drill the holes you traced
through the slots.
2. Screw the mounting plate into position
using the self-tapping screws provided.
3. Connect all the required leads to the unit.
4. Screw the unit to the mounting plate
using the five machine screws provided.
5. Cover the three rear screw holes with the
rubber caps provided.
6. Snap the two interior light covers back
into position.
Electrical connections.
Route all cables with care. Do not cut off
un-used cables, tape them up and secure
them to one side. They may be useful in the
future for additional functions.
11
Power supply connections
Cable color Category
Yellow input
Red input
Black input
White input
If the yellow +12v permanent positive lead is
lengthened and connected directly to the
battery, it must be protected by an additional
10 Amp fuse located near the battery
(max.10-15 cm).
+12 V permanent lead (yellow):
Connect the yellow lead to a suitable
connector with +12v permanent positive
voltage.
This connection should be rated for a
current of at least 3 amps.
+12 V switched lead (red):
Connect the red lead to a suitable +12v
circuit switched through the ignition.
Battery negative lead (black):
Connect the black lead to a suitable ground
(vehicle chassis).
Connection
+12v permanent positive
(must be rated for at least 3
amps)
+12v ignition positive
(switched plus)
Battery negative (vehicle
chassis)
Door contact/interior lighting
(must be rated for at least 1
amp)