Installation; Radio Antenna; Installation Orientation; Fitting The Bracket - Blaupunkt CHICAGO IVDM-7002 Installation Instructions Manual

Assembly

2. Installation

2.1 Radio antenna

In ready-fitted vehicles (e.g. VW, Seat,
Audi) the antenna supply voltage is
provided through the antenna cable
(see the vehicle's user instructions).
You can obtain an antenna supply
junction piece (order no. 7 691 290
202) or the adapter cable (order no.
7 607 621 129) from your dealer.
Fitting and connecting the cable are
described in the antenna fitting instruc-
tions.

2.2 Installation orientation

The device must be fitted at an angle
of between 0° and +20°. The Chicago
IVDM-7002 is not suitable for vertical
fitting.

2.3 Fitting the bracket

The bracket included with the Chica-
go IVDM-7002 allows it to be mounted
in vehicles with a DIN car radio slot with
dimensions of 182 x 53 x 180 mm and
with instrument panels that are be-
tween 1 and 20 mm thick in the region
of the securing tabs (see Fig. 3). To
mount the device you must push the
bracket into the opening and check
which of the bracket's securing tabs
can be bent over with a screwdriver
(see Fig. 3a).
Note: Bend all the securing tabs if
possible.

2.4 Mounting the monitor unit

Push all the plugs fully into their cham-
bers so that they engage. Then place
the Chicago IVDM-7002 into the brack-
et at the front (see Fig. 3).
Push the device in by gently pressing
both ends of the frame until the catch
springs at the side lock into place (you
will hear a distinct click).
Warning! Do not press the display,
knobs or switches when pushing
the device into place!

2.5 Removing the monitor unit

Remove the plastic masking frame. You
must now push the clips in between the
device and the mounting frame on the
left and the right, and press them in until
a distinct click can be heard (the springs
at the side disengage). Now carefully
withdraw the Chicago IVDM-7002 us-
ing the two clips. The connecting cable
can now be released and withdrawn
(see Fig. 4).
Note: When the clips have engaged,
they can only be removed by with-
drawing the Chicago IVDM-7002.

2.6 Fitting the amplifier

Mount the amplifier in a suitable loca-
tion using the enclosed angle bracket
(see Fig. 5).
Make sure that the fan's outlet open-
ing is not covered. Use the connecting
cable to join the tuner unit to the mon-
itor unit (see Fig. 2).
10